Written by Following pictures show different steps of making an LED bracelet with small 3mm yellow LEDs and pieces of brass tube. Hover your mouse on top of each of the pictures to see details about
-
- 01-pick some flat top LEDs and shape them like this (Custom)
-
- 02-to shape them first bend the longer pin over the LED body and bend it afterwards (Custom)
-
- 03-place them one after another and if needed cut the extra lenght of pins (Custom)
-
- 04-Start soldering the pins together (be careful to connect plus to plus and onwards) (Custom)
-
- 05-You will end up with something like this (Custom)
-
- 06-Depending on your spacing and wrist size you may have less or more LEDs (Custom)
Leave a Reply